Managed Switch CLI Manual, Release 8.0
Utility Commands
6-20
v1.0, July 2009
no logging console
This command disables logging to the console.
logging host
This command enables logging to a host. You can configure up to eight hosts. The
<ipaddr|hostname>
is the IP address of the logging host. The
<addresstype>
indicates
the type of address ipv4 or ipv6 or dns being passed. The
<port>
value is a port number from 1
to 65535. You can specify the
<severitylevel>
value as either an integer from 0 to 7 or
symbolically through one of the following keywords:
emergency
(0),
alert
(1),
critical
(2),
error
(3),
warning
(4),
notice
(5),
info
(6), or
debug
(7).
logging host remove
This command disables logging to host. See
“show logging hosts” on page 6-22
for a list of host
indexes.
logging syslog
This command enables syslog logging. The
<portid>
parameter is an integer with a range of 1-
65535.
Format
no logging console
Mode
Global Config
Default
• port—514
• level—critical (2)
Format
logging host <ipaddr|hostname> <addresstype>
[<port>][<severitylevel>]
Mode
Global Config
Format
logging host remove <hostindex>
Mode
Global Config
Default
disabled
Format
logging syslog [port <portid>]
Mode
Global Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
