Managed Switch CLI Manual, Release 8.0
Quality of Service (QoS) Commands
5-5
v1.0, July 2009
traffic-shape
This command specifies the maximum transmission bandwidth limit for the interface as a whole.
Also known as rate shaping, traffic shaping has the effect of smoothing temporary traffic bursts
over time so that the transmitted traffic rate is bounded.
no traffic-shape
This command restores the interface shaping rate to the default value.
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The
<unit/slot/port>
parameter is optional and is only valid on
platforms that support independent per-port class of service mappings. If specified, the 802.1p
mapping table of the interface is displayed. If omitted, the most recent global configuration
settings are displayed. For more information, see
“Voice VLAN Commands” on page 3-47
.
The following information is repeated for each user priority.
Format
traffic-shape <bw>
Modes
• Global Config
• Interface Config
Format
no traffic-shape
Modes
• Global Config
• Interface Config
Format
show classofservice dot1p-mapping [<unit/slot/port>]
Mode
Privileged EXEC
Term
Definition
User Priority
The 802.1p user priority value.
Traffic Class
The traffic class internal queue identifier to which the user priority value is mapped.
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
