Managed Switch CLI Manual, Release 8.0
Management Commands
7-48
v1.0, July 2009
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able to
receive traps). Disabled trap receivers are inactive (not able to receive traps).
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
snmp trap link-status
This command enables link status traps by interface.
Note:
IP addresses in the SNMP trap receiver table must be unique. If you make multiple
entries using the same IP address, the first entry is retained and processed. All
duplicate entries are ignored.
Format
snmptrap ipaddr
<name> <ipaddrold> <ipaddrnew>
Mode
Global Config
Format
snmptrap mode <name> <ipaddr>
Mode
Global Config
Format
no snmptrap mode
<name> <ipaddr>
Mode
Global Config
Note:
This command is valid only when the Link Up/Down Flag is enabled. See
“snmp-
server enable traps linkmode” on page 7-45
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
