Managed Switch CLI Manual, Release 8.0
Management Commands
7-55
v1.0, July 2009
when connecting to the RADIUS accounting server. If a
<port>
is already configured for the
accounting server, the new
<port>
replaces the previously configured
<port>
. The
<port>
must be a value in the range 0 - 65535, with 1813 being the default.
no radius server host
The
no
version of this command deletes the configured server entry from the list of configured
RADIUS servers. If the RADIUS authenticating server being removed is the active server in the
servers that are identified by the same server name, then the RADIUS client selects another server
for making RADIUS transactions. If the 'auth' token is used, the previously configured RADIUS
authentication server is removed from the configuration. Similarly, if the 'acct' token is used, the
previously configured RADIUS accounting server is removed from the configuration. The
<ipaddr|dnsname>
parameter must match the IP address or dns name of the previously
configured RADIUS authentication / accounting server.
The following shows an example of the command.
(Switch) (Config) #radius server host acct 192.168.37.60
(Switch) (Config) #radius server host acct 192.168.37.60 port 1813
Note:
To re-configure a RADIUS accounting server to use the default UDP
<port>
, set
the
<port>
parameter to 1813.
Format
radius server host
{
auth | acct
}
{
<ipaddr|dnsname>
} [name
<servername>] [port <
0-65535
>][server-type]
Mode
Global Config
Field
Description
ipaddr
The IP address of the server.
dnsname
The DNS name of the server.
0-65535
The port number to use to connect to the specified RADIUS server.
servername
The alias name to identify the server.
Format
no radius server host
{auth | acct}
{
<ipaddr|dnsname>
}
Mode
Global Config
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
