Managed Switch CLI Manual, Release 8.0
Stacking Commands
2-6
v1.0, July 2009
no set slot power
This command unconfigures the power mode of the slot(s) and prohibits power from being
supplied to a card located in the slot. If you specify
[all]
, the command prohibits power to all
slots, otherwise the command prohibits power to the slot identified by
<unit/slot>
.
Use this command when installing or removing cards. If a card or other module is present in this
slot, power is prohibited to the contents of the slot. If the slot is empty, power is prohibited to any
card inserted into the slot.
reload (Stack)
This command resets the entire stack or the identified
<unit>
.
The
<unit>
is the switch
identifier. The system prompts you to confirm that you want to reset the switch.
show slot
This command displays information about all the slots in the system or for a specific slot.
Format
no set slot power
[<unit/slot> | all]
Mode
Global Config
Format
reload
[<unit>]
Mode
User EXEC
Format
show slot [<unit/slot>]
Mode
User EXEC
Term
Definition
Slot
The slot identifier in a <
unit/slot
> format.
Slot Status
The slot is empty, full, or has encountered an error
Admin State
The slot administrative mode is enabled or disabled.
Power State
The slot power mode is enabled or disabled.
Configured Card
Model Identifier
The model identifier of the card preconfigured in the slot. Model Identifier is a 32-
character field used to identify a card.
Summary of Contents for FSM726v3 - ProSafe Fast Ethernet L2 Managed Switch
Page 4: ...v1 0 July 2009 iv...
