Motorola WiNG 4.4, Reference Manual

Page: 351 / 598

Switch Services 5 - 71
10.To use the onboard SOLE engine to locate Ekahau tags check the Enable checkbox. This is enabled immediately after
checking the box.
11.If the onboard SOLE engine is enabled to locate Ekahau tags, enter a Locate Interval in seconds to specify how often
the known tags are located by the SOLE engine.
12.Click the Apply button to save the Locate Interval value.
13.Click the Revert button to cancel any changes made within Locate Interval value and revert back to the last saved
configuration.
If the onboard SOLE engine is enabled to locate Ekahau tags the following information will be displayed for each located
MU:
Last Msg TX Time Displays the Date and Time that the last message was sent to the external Ekahau RTLS engine.
No. of Tag Reports Displays the number of Tag Reports received from the external Ekahau RTLS engine.
MAC Lists the MAC Addresses of all MUs which have been located by the switch.
Location:
X Coordinate Displays the value of the X Coordinate for each located MU. The X coordinate is relative to the
origin point of 0,0 in the upper left corner of the site map.
Location:
Y Coordinate Displays the value of the Y Coordinate for each located MU. The X coordinate is relative to the
origin point of 0,0 in the upper left corner of the site map.
Timestamp Displays the last time for each MU that its location was computed by the switch.
Zone Lists the last known zone for each located MU. Zone configuration can be defined using the CLI
interface only. When no zones are configured, the switch defaults the entire site to Zone 0.
NOTE: Zone configuration can be defined using the CLI interface only. For information on Zone
Configuration please see the Motorola Solutions RF Switch CLI Reference.