Motorola WiNG 4.4, Reference Manual, Page: 347 / 598

Switch Services 5 - 67
1. . Services > RTLS from the main menu tree.
2. Select the SOLE tab.
3. Check the Locate All Mobile-Units checkbox to locate all MUs known to the switch across all WLANs. This will also
disable manual entry of MU MAC addresses in the field below.
This takes effect immediately when the box is checked.
4. Enter a value for the MU Locate Interval in seconds. The MU Locate Interval determines how often the locationing
of MUs is updated. The valid range for this is between 5 to 3600 seconds.
5. Click the Apply button to save the MU Locate Interval value.
6. Click the Revert button to cancel any changes made within MU Locate Interval value and revert back to the last saved
configuration.
7. The MU MAC table allows you to manually add or remove MAC Addresses which can be located by the SOLE engine.
This supports a maximum of 512 MUs. This table is disabled when the Locate All MUs checkbox is selected.
a. To add MUs to the MU MAC table click the Add button to open a dialogue box allowing you to add a MAC Address
to the MU MAC table allowing it to be located by the switch's SOLE engine.
b. To remove a MAC Address from the MU MAC table select a MAC Address from the table and click the Delete
button to remove that MU. This table is disabled when the Locate All MUs checkbox is selected.
NOTE: AP coordinates can only be configured in the Command Line Interface. For more information
on configuring AP coordinates please consult the Motorola Solutions RF Switch CLI Reference.