Motorola WiNG 4.4, Reference Manual

Page: 571 / 598

C - 13
C.4 Rogue AP Detection Troubleshooting
Motorola Solutions recommends adhering to the following guidelines when configuring Rogue AP detection:
• Basic configuration required for running Rogue AP detection:
• Enable any one of the detection mechanism.
• Enable rogueap detection global flag.
• After enabling rogueap and anyone of the detection mechanisms, look in the roguelist context for detected APs. If no
entries are found, do the following:
• Check the global rogueap flag by doing a show in rogueap context. It should display Rogue AP status as "enable"
and should also the status of the configured detection scheme.
• Check for the "Motorola AP" flag in rulelist context. If it is set to "enable", then all the detected APs will be added
in approved list context.
• Check for Rulelist entries in the rulelist context. Verify it does not have an entry with MAC as "FF:FF:FF:FF:FF:FF" and
ESSID as "*"
• If you have enabled AP Scan, ensure that at least a single radio is active. AP scan does not send a scan request to an
inactive or unavailable radio.
• Just enabling detectorscan will not send any detectorscan request to any adopted AP. User should also configure at
least a single radio as a detectorAP. This can be done using the set detectorap command in rogueap context.