![Keysight E6640A Measurement Applications User & Programmer Reference Download Page 1148](http://html1.mh-extra.com/html/keysight/e6640a/e6640a_measurement-applications-user-and-programmer-reference_19616451148.webp)
10 Spectrum Emission Mask Measurement
Source
LTE TDD Channel Number Ranges
The carrier frequency in the uplink and downlink is designated by the E-UTRA Absolute Radio Frequency
Channel Number (EARFCN) in the range 0 – 65535. The relation between EARFCN and the carrier
frequency in MHz for the downlink is given by the following equation, where FDL_low and NOffs-DL are
given in table 5.4.4–1 and NDL is the downlink EARFCN.
FDL = F 0.1(NDL – NOffs-DL)
The relation between EARFCN and the carrier frequency in MHz for the uplink is given by the following
equation where FUL_low and NOffs-UL are given in table 5.4.4–1 and NUL is the uplink EARFCN.
FUL = F 0.1(NUL – NOffs-UL)
Band
Downlink
Uplink
F
DL_low
(
MHz
)
N
Offs-DL
Range of
N
DL
F
UL_low (
MHz
)
N
Offs-UL
Range of
N
UL
33
1900
36000
36000 –36199
1900
36000
36000 – 36199
34
2010
36200
36200 –36349
2010
36200
36200 – 36349
35
1850
36350
36350 –36949
1850
36350
36350 – 36949
36
1930
36950
36950 –37549
1930
36950
36950 – 37549
37
1910
37550
37550 –37749
1910
37550
37550 – 37749
38
2570
37750
37750 –38249
2570
37750
37750 – 38249
39
1880
38250
38250 –38649
1880
38250
38250 – 38649
40
2300
38650
38650 –39649
2300
38650
38650 – 39649
41
2496
39650
39650 – 41589
2496
39650
39650 – 41589
42
3400
41590
41590 – 43589
3400
41590
41590 – 43589
43
3600
43590
43590 – 45589
3600
43590
43590 – 45589
Note: The channel numbers that designate carrier frequencies so close to the operating band edges that the carrier extends
beyond the operating band edge shall not be used. This implies that the first 7, 15, 25, 50, 75 and 100 channel numbers at the
lower operating band edge and the last 6, 14, 24, 49, 74 and 99 channel numbers at the upper operating band edge shall not
be used for channel bandwidths of 1.4, 3, 5, 10, 15 and 20 MHz respectively.
TDSCDMA Channel Number Ranges
1.28 Mcps TDD Option
No TX-RX frequency separation is required as Time Division Duplex (TDD) is employed. Each subframe
consists of 7 main timeslots where all main timeslots (at least the first one) before the single switching
point are allocated DL and all main timeslots (at least the last one) after the single switching point are
allocated UL.
The nominal channel spacing is 1.6 MHz, but this can be adjusted to optimise performance in a particular
deployment scenario.
The carrier frequency is designated by the UTRA absolute radio frequency channel number (UARFCN). The
value of the UARFCN in the IMT2000 band is defined in the general case as follows:
1148
W-CDMA & HSPA Measurement Applications Reference
Summary of Contents for E6640A
