Keysight E6640A, Measurement Applications User & Programmer Reference

Page: 1070 / 2870

10 Spectrum Emission Mask Measurement
Meas Setup
If the current mode is DVB-T/H, this value will be modified automatically according to the output
power of the transmitter which is less or more than 25W.
If the current mode is ISDB-T, this value will be modified automatically according to the limit type.
Preset Automatically calculated
Modes (except MSR, LTEAFDD, LTEATDD and WLAN) without option N9060A–7FP: ON, ON, ON,
ON, ON, ON
Modes (except MSR, LTEAFDD, LTEATDD and WLAN) with option N9060A–7FP: ON, ON, ON, ON,
ON, ON, ON, ON, ON, ON, ON, ON
WLAN: ON, ON, ON, ON, ON, ON, ON, ON, ON, ON, ON, ON
State Saved Saved in instrument state.
Min TBD
Max 4000 s
Backwards
Compatibility SCPI [:SENSe]:SEMask:OFFSet[1]|2:LIST:SWEep[:TIME]
Initial S/W Revision Prior to A.02.00
Modified at S/W Revision A.02.00, A.03.00, A.10.00, A.11.00, A.14.00
Offset Side
Specifies which offset side to measure.
You can turn off (not use) specific offsets with [:SENSe]:SEMask:OFFSet[n][:OUTer]:LIST:STATe.
•
BOTH – Both of the negative (lower) and positive (upper) sidebands
•
NEGative – Negative (lower) sideband only
•
POSitive – Positive (upper) sideband only
Missing values are not permitted; that is, if you want to change values 2 and 6, you must send all values up
to 6. Subsequent values will remain as they were. The query for this parameter always returns 12 values.
The figure below shows the relation between the negative/positive offset side setups and the upper/lower
results in the MSR and LTE-Advanced FDD/TDD.
1070 W-CDMA & HSPA Measurement Applications Reference