IMPORTANT NOTE: It is possible to patch round the Equalizer by patching the output of
the Input Source (preamp or multitrack return) directly to the
FADER Input for the desired audio path. This will also bypass the
200 Slot routing and insert for that path.
17.2.2 Channel Patch Points for Multitrack Recording
The next two sections will show the channel patch points normally associated with each path
during a typical multitrack recording session. The following conditions apply:
•
212L Mic Preamp, 225L Compressor, and 550L EQ are fitted in their respective slots
•
Input Selectors are in their default positions (Fader 2 MIC, Fader 1 TAPE)
•
The EQ is assigned to Fader 2 and is engaged
•
The multitrack recorder is patched to be fed from the Direct Output (not shown)
•
The Direct Output is assigned to Fader 2 (DIR switch engaged) and patched to a
multitrack recorder
•
The Lower 200 Slot is programmed to be Pre EQ in Fader 1
EQUALIZER INPUT: Equalizer Input (500 Slot In)
•
Replaces the feed to the Equalizer Input
•
Post the CHANNEL INPUT
EQUALIZER OUTPUT: Equalizer Output (500 Slot Out)
•
Always active
The Equalizer is located:
•
Post the CHANNEL INPUT
•
Pre INSERT SEND or the 200 Slot Input if so
programmed
•
Assignable to Fader 1 or Fader 2 audio path
DIRECT OUTPUT: Channel Direct Output
•
Fed from FADER 1 by default
•
Will be fed from Fader 2 if the DIR switch is
engaged
The Direct Output is located:
•
Post the Direct Output switch (Post-fader)
FADER 1 FDR INPUT: Fader 1 Fader Input
•
Replaces the feed to the Fader 1 Fader Input
The Fader 1 Fader Input is located:
•
Post Insert Return
•
Pre Phase Reverse (Polarity Inverter)
FADER 1 INSERT SEND: Fader 1 Insert Send
•
Always active
FADER 1 INSERT RETURN: Fader 1 Insert Return
•
Replaces the feed to the channel Fader Input
when the Fader 1 INS switch is engaged
The Fader 1 Insert is Located:
•
Post EQ or the 200 Slot Output if so
programmed
•
Pre FADER 1 FDR INPUT
