IMPORTANT NOTE: It is possible to patch round the Equalizer by patching the output of
the Input Source (preamp or multitrack return) directly to the
FADER Input for the desired audio path. This will also bypass the
200 Slot routing and insert for that path.
3.8.2
Channel Patch Points For Multitrack Recording
The next two sections will show the channel patch points normally associated with each path
during a typical multitrack recording session. The following conditions apply:
•
212L Mic Preamp, 225L Compressor, and 550L EQ are fitted in their respective slots
•
Input Selectors are in their default positions (Fader 2 MIC, Fader 1 TAPE)
•
The EQ is assigned to Fader 2 and is engaged
•
The multitrack recorder is patched to be fed from the Direct Output (not shown)
•
The Direct Output is assigned to Fader 2 (DIR switch engaged) and patched to a
multitrack recorder
•
The Lower 200 Slot is programmed to be Pre EQ in Fader 1
3.8.2.1
Fader 2 Patch Points (Multitrack Send Audio Path)
The patch points below are the patch points normally associated with the Fader 2
audio path during a typical multitrack recording session. In this scenario, Fader 2
is used to route microphone inputs to a multitrack recorder via the Direct Output.
EQUALIZER INPUT: Equalizer Input (500 Slot In)
•
Replaces the feed to the Equalizer Input
•
Post the CHANNEL INPUT
EQUALIZER OUTPUT: Equalizer Output (500 Slot Out)
•
Always active
The Equalizer is located:
•
Post the CHANNEL INPUT
•
Pre INSERT SEND or the 200 Slot Input if so
programmed
•
Assignable to Fader 1 or Fader 2 audio path
DIRECT OUTPUT: Channel Direct Output
•
Fed from FADER 1 by default
•
Will be fed from Fader 2 if the DIR switch is
engaged
The Direct Output is located:
•
Post the Direct Output switch (Post-
fader/mute)
MIC TIE LINE OUT: Studio Microphone Tie-
line Outputs
•
Fully-normalled to MIC PREAMP
IN
MIC PREAMP IN: Connection point to the
Preamp Input (Upper 200 Slot In or
Options Bucket In)
•
Feeds the preamp input
•
Fully-normalled from MIC TIE
LINE OUT
•
Patching to these points will
replace the mic tie-line feed to
the preamp with the patch cord
signal
•
Not used with 205L Direct Input
module
