3.8.2.2
Fader 1 Patch Points (Multitrack Return Audio Path)
The patch points below are the Patch Points normally associated with the Fader 1
audio path during a typical multitrack recording session. In this scenario, Fader 1
is used to route multitrack returns to a mix bus (not shown).
MULTITAPE OUTPUT: Multitrack Recorder
Output (Multitrack Return)
•
Feeds the input to the channel
Input Selector switch (MIC and
TAPE) in both paths (Fader 1 and
Fader 2)
•
The MULTITAPE OUTPUT is the
default source for Fader 1
•
Fader 2 will receive the
MULTITAPE OUTPUT when the
Fader 2 TAPE switch is engaged
•
Both paths may receive the signal
from MULTITAPE OUTPUT
simultaneously
COMP IN: Compressor Input (200 Slot
Input)
•
Half-normalled to COMP SIDE
CHAIN IN
COMP SIDE CHAIN IN: Compressor Side-
Chain Input (200 Slot Side-chain Input)
•
Half-normalled from COMP IN
COMP OUT: Compressor Output (200 Slot
Output)
•
Returns Pre or Post EQ in the
programmed audio path (Fader 1
or Fader 2) (See Lower 200 Slot
Patching below)
DIRECT OUTPUT: Channel Direct Output
•
Fed from FADER 1 by default
•
Will be fed from Fader 2 if the
DIR switch is engaged
The Direct Output is located:
•
Post the Direct Output switch
(Post-fader/mute)
FADER 1 CHANNEL INPUT: Fader 1 audio
path input
•
Replaces the feed to the Fader 1
Channel Input
The FADER 1 CHANNEL INPUT is located:
•
Post the Input Selector switch or
the 200 Slot Output if so
programmed
•
Pre EQ
FADER 1 INSERT SEND: Fader 1 Insert
Send
•
Always active
FADER 1 INSERT RETURN: Fader 1
Insert Return
•
Replaces the feed to the
channel Fader Input when the
Fader 1 INS switch is engaged
The Fader 1 Insert is Located:
•
Post EQ or the 200 Slot Output
if so programmed
•
Pre FADER 1 FDR INPUT
