26.5.4.2
Vision Control Panel Mode and Submode Assignment
To assign an automation mode or submode to channel sections using the Vision
Control Panel, use the following procedure:
1.
Select the desired channel section(s) by pressing the “Section Select”
button until the desired section(s) have been selected
2.
Press the desired automation mode and/or submode button(s)
3.
The selected channel section(s) will change status to the new mode or
submode
Note: Mode and submode assignments made on the console (VCP and fader
modules) have nothing to do with the assignments made in the computer
software.
Automation modes and submodes can be assigned to
channel sections on a global basis using the Vision
Control Panel (VCP).
Note: Channel section selections made on individual
channels are overwritten when the Section
Select button is pressed on the VCP.
Section Select: Cycles the selection of
channel sections on a global basis
•
Each consecutive press steps
through the selection of channel
sections
o
Fader 1
o
Fader 2
o
Switches
o
All (Fader 1, Fader 2, and
Switches)
Channel sections can also be selected
locally on a channel by channel basis
using the SEL button on the fader
module.
SEL (Select): Selects channel sections
on individual channels
•
Channels sections will be cycled
when the “SEL” button is pressed
Once channel sections
have been selected, modes
and submodes can be
globally assigned using the
buttons on the Vision
Control Panel.
