In the example below, the cursor is over Fader 1 on Channel 1, its automation mode is
Read and no submodes are engaged.
26.4.4
Selecting Channel Sections Using Hardware
Channel sections and Master faders can be selected via hardware in two ways:
•
Globally: Using the “Section Select” button on the Vision Control Panel (VCP)
•
Individually: Using the “SEL” button on individual fader modules
Section Select: Global channel section selector button
•
Each press will cycle all channels through:
o
Fader 1
o
Fader 2
o
All (Fader 1, Fader 2, Switches)
SEL (Select): Channel section selector button
•
Each press will cycle through the following channel sections:
o
Fader 1 (the yellow “FD 1” LED will illuminate when selected)
o
Fader 2 (the yellow “FD 2” LED will illuminate when selected)
o
Switches (the yellow “SW” LED will illuminate when selected)
o
All sections (all 3 yellow LEDs will be illuminated when selected)
•
Pressing and holding this button will toggle the 2=1 mode on and off
o
Fader 2 will mirror the Fader 1 position when engaged
o
The green “2=1” LED will illuminate when 2=1 is engaged
•
The mode of the selected section(s) is displayed on the fader’s mode LEDs
Note: The section select LEDs on the fader are only used for local control of
the operation of the buttons on that fader. They also control which
section’s modes are displayed on the mode LEDs of that fader. In other
words, they have nothing at all to do with selections made in the
computer software.
