Terumo 801763, Operator'S Manual, Page: 74 / 359

Central Control Monitor
4-12
Perfusion Screen
Although a Perfusion Screen can be customized to accommodate many different
perfusion setups, all Perfusion Screens share some common characteristics including
the patient and perfusion circuit graphics, message area, system time, power source/
battery status icon, primary pump, pump and clamp timers, pump control area, tabs,
control slide bars, and device icons.
Primary Pump
A Perfusion Screen must have a primary pump, usually the arterial pump, designated
in the Configuration area. The controls and displays for this pump are always
displayed on the right or left side of the Perfusion Screen.
Setup Safety CPG Aux System
Post Case
PCO2
K+
pH
mmHg
PO2
mmHg
mmol/L
16:07:51
Arterial
0.000
L/min
10.78
0
Clamp
Reset
Reset
000:00
Pump
Reset Reset
000:00
SO2
%
%
HCT
Arterial
L/min
START
Vent
L/min
START
Sucker1
L/min
START
Sucker2
L/min
START
CPG
L/min
START
mmHg
C
mmHg
mmHg
C
C
C
VO2
mL/min
Gas % O2
0 0
To Open a Perfusion Screen:
1. Touch the Perfusion Screen name. The selected screen will be highlighted.
2. Touch the
Open
button.
3. Enter password if the screen is password protected. The CCM will open and
display the Perfusion Screen. When a Perfusion Screen is opened, the status
of all devices that are a part of the Perfusion Screen will change from offline to
online. Online pumps display the pump name and the LED of online modules is
constant green.