Terumo 801763, Operator'S Manual, Page: 111 / 359

Central Control Monitor
4-48
WARNING: Hand cranks must be properly setup to allow hand cranking in same
direction as that selected for forward flow for the roller pump.
WARNING: All roller pumps used in a hospital must be set to run in the same
default direction for forward flow to prevent unintended retrograde pumping.
RETROGRADE PUMPING MAY CAUSE SEVERE PATIENT INJURY OR DEATH.
System Settings
System settings are language, date format, and roller pump direction. The user can
change the settings, edit configuration passwords, or copy and back up Perfusion
Screens using PC cards.
To Change Settings:
1. Touch the Change Settings button to choose or change language, date format,
or default roller pump direction.
2. Touch the selection on the screen, and verify that the new selection is highlighted.
3. Touch the
OK button to exit the screen and save the changes.
4. Touch
Cancel
to exit and keep the previous settings.
Note:
Pumps connected to the base will have their direction changed to match
the new system direction just selected, unless the pump is activated. If the pump is
activated when the new system direction is selected, the pump will continue running
in its original direction until the system is restarted or the pump is turned off and a
Perfusion Screen is opened.
CAUTION:
Pumps will be activated at 0 RPM. Check the pump display or CCM
to ensure the pumps are stopped before changing the system direction.
When the roller pump direction is changed, a warning appears on the screen
prompting the user to change the direction on the hand cranks to match the changed
roller pump direction. Refer to the
System Base
chapter for instructions on changing
the hand crank direction.
Cancel
Language:
English
System Settings
OK
Date Format:
Roller Pump Direction:
mm/dd/yyyy
dd/mm/yyyy
OK
Warning! Be sure to change hand crank direction to match
new roller pump direction.