Terumo 801763, Operator'S Manual, Page: 205 / 359

Centrifugal Control Unit
6-6
Controls and Displays
CAUTION: Pump control panels and Central Control Monitor are intended for
hand and gloved hand operation only. Do not use any instruments on the pump
control panels or Central Control Monitor as this may damage the device.
Start/Stop Button
Press the Start/Stop button to activate and start the pump. The
pump speed will always begin at 0 RPM when the pump is started.
The presence of a 0 before RPM indicates that the centrifugal pump
is activated. If 0 does not appear before RPM, the centrifugal pump
is deactivated. If the Start/Stop button is pressed while the pump is
running and the speed is greater than 1550 RPM, the message “TURN
SPEED TO ZERO” will be displayed in the message area. Pressing the
Start/Stop button again within four seconds will stop the pump. If the
speed is less than 1550 RPM, pressing the Start/Stop button once will
stop and deactivate the pump. If the pump is stopped and deactivated
using the Start/Stop button, it must be reactivated using the Start/Stop
button for the pump to be used again.
Select Button
Pressing the Select button will reset an active air alarm on a
connected Air Bubble Detection system.
Manual Button
Pressing the Manual button will result in the following responses
depending on the pump state:
•
No response if pump is stopped.
• No response if pump is running in Continuous mode.
• Return to Continuous mode if in Pulse mode.
• Return to Continuous mode if in Servo mode.
Pump Speed Control Knob
Use the pump speed control knob to set the pump speed. Turning the
knob clockwise increases the speed, counterclockwise decreases the
speed.
Note: Unlike a roller pump, turning the centrifugal pump speed control
knob to a speed of 0 RPM will stop and deactivate the centrifugal pump.
ARTERIAL
0 RPM
L/min
0.000
Centrifugal Icon Pump Name
Message Area
Motor Speed
Primary Display
Secondary Display
Mode Symbol
Bar Graph
Pump Speed Control Knob