Terumo 801763, Operator'S Manual, Page: 224 / 359

Modules
7-4
Air Bubble Detection (ABD)
Enabling, Resetting, or Disabling Air Bubble Detection Alarms
Select the Air subtab within the Safety tab on the Perfusion Screen or touch the Air
icon on the CCM.
1. Touch the air detection On button to enable the alarm capability for the air
detection system and the icon on the CCM turns green.
2. Touch the air detection Off button to disable the alarm capability for the air
detection system and the icon on the CCM turns gray.
3. When air is detected, correct the condition, and then touch the Reset button
on the CCM to clear an air alarm and leave the air bubble detector enabled. If
an air detector has a safety connection to a pump, the alarm can also be reset
by touching the
Select button on the pump control panel after the air has been
cleared. The ABD is the only safety device that requires a reset by the user to
confirm that the issue has been addressed. All other safety devices automatically
reset when the issue is resolved.
System Response to Air Bubble Detection Alarm
Air Air Connected Audible
Icon Module Message Device(s) Tone
Flashes red LED flashes Message with sensor name Respond as Dual-tone
red in the CCM message area configured alarm
and on the local display of any
pumps with an air safety
connection. Safety tab opens.
The alarm state will clear when the condition is corrected and the air bubble detection
system is Reset or turned Off.
Note: The ABD system will alarm when the air sensor is disconnected from the
module.
Safety
ART Air
Next
Reset
Level
16:07:51
Air
Pressures
Off
On
On Button
Off Button
Reset Button