Terumo 801763, Operator'S Manual, Page: 51 / 359

System Base
3-12
Position 1 Position 2 Position 3
Standoffs are provided in the accessories kit. Two standoffs should be installed on a
module receptacle to securely fasten a pump cable or flowmeter cable to the module
receptacle. Modules cannot be inserted into a module receptacle when standoffs are
installed.
Casters and Wheel Lock System
The base is mounted on four casters. Each side of the base has a pair of casters
and a locking lever that can be set in three positions to either lock the wheels of the
casters to prevent unintended movement of the base, allow free movement of the
casters and wheels, or lock the casters to allow the base to roll while maintaining a
fixed position of the wheels.
Apply upward or downward pressure on the locking lever to change the position.
Position 1
The casters are locked in place and will not move. When the system is in use, the
wheel lock should be set in the locked position.
Position 2
The casters are unlocked and move in all directions.
Position 3
The casters align parallel to the base and allow side-to-side movement only.
Poles, Shelf, and Brackets
There are two 1.30 in. (3,3 cm) diameter, stainless steel
vertical telescoping poles attached to the base platform
for mounting devices to the system.
Extend the inner section of the telescoping pole by
adjusting the handle screw on the collar of the pole. Do
not extend beyond a maximum of 18 in. (45,7 cm) from
the retracted position.
Special fittings connect a horizontal cross bar to the two vertical poles.