Terumo 801763, Operator'S Manual, Page: 160 / 359

Central Control Monitor
4-94
Assign Pressure and Temperature Sensors
Select device type.
Touch the Assign Devices button.
1. On the base, locate the module with the green flashing light. Select
‘Channel 1’ or ‘Channel 2’.
If there is only one device of the type selected on the system base, there will
only be one module with a flashing light. If there is more than one device of the
type selected on the system base, touch the
Go To Next Module
button until
the desired module is flashing. Select the appropriate channel. Channel 1 on a
pressure module is marked with the green label and Channel 2 is marked with
the yellow label. Channel 1 on a temperature module is marked with a blue label
and Channel 2 is marked with a red label. Make sure that the sensor cable for
the sensor being assigned is connected to the channel selected.
2. To assign a configuration device to the selected channel, touch the device
in the unassigned list, then touch the ‘Assign’ button. Repeat the process
for the other channel.
The device name will move from the Unassigned list to the Assigned list. The
device name appears in the box labeled Channel 1 or Channel 2 in the top
section of the screen.
Devices that appear in the Assigned list may be unassigned by touching the
name of the device and then touching the
Unassign
button.
2. To assign a configuration device to the selected channel:
Touch the device in the unassigned list, then touch the 'Assign' button.
Repeat the process for the other channel.
Unassigned:
Assigned:
3. To assign another Pressure Sensor device:
Touch the 'Go to Next Module' button and repeat from step 1.
ART Pres
Assign > Assign >
< Unassign < Unassign
Cancel OK
Assign Configuration Device to Physical Module: Pressure Sensors
1. On the base, locate the module with the green flashing light.
Select 'Channel 1' or 'Channel 2'.
Go to Next Module
Channel 2
Channel 1 Assigned:
Assigned: Assigned:
CPG Pres