Terumo 801763, Operator'S Manual, Page: 230 / 359

Modules
7-10
Level Monitoring
Selecting the Level Detection Mode
Touch the Level Detection button to select the desired mode: Alert Only when
using only the alert sensor or select Alert/Alarm when using both the alert and alarm
sensors.
• When switching to Alert/Alarm from Alert Only , the level alarm probe will take
approximately 10 seconds to initialize.
The operating mode is established during configuration of the Perfusion Screen.
Changes to the configured mode made during a perfusion case are retained only for
the current case. The mode will revert to the mode chosen during configuration when
the case is exited.
Enabling and Disabling Level Detection System
Use the alert/alarm warnings to warn of changing level conditions that may allow the
blood or prime solution level to fall below optimum conditions.
Select the Level subtab within the Safety tab on the Perfusion Screen or touch the
Level icon on the CCM.
1. Touch the level detection On button to enable the alert and alarm capability for
level detection and the icon on the CCM turns green.
2. Level detection
Off
button disables the alert and alarm capability for the level
detection and the icon on the CCM turns gray.
Alert/Alarm Alert Only
Safety
Level
Alert/Alarm
Air
Next
Off
Level Detection:
16:07:51
Level
Pressures
On
On and Off Buttons Level Detection Button
Device Name Button