Sony SRW-5000, Maintenance Manual, Page: 412 / 438

8-14
SRW-5000/5500
Saving the Data
n
Do not save the adjustment data if any automatic adjust-
ment was not completed properly.
7. Press the
[F1]
(NVRAM CTL) key to display the NV-
RAM CONTROL menu.
8. Select the “SAVE ALL DATA” by pressing the cursor
keys, then press the
[F10]
(EXIT) key to saving data.
.
The message “Save Complete” will be displayed
when this data save is completed normally.
9. Eject the alignment tape.
10. In case of the option HKSR-5002 installed model,
perform the next adjustment “3. Digital BETACAM
Format”.
In case of the option HKSR-5002 is not installed, exit
the maintenance mode and perform “4. Adjustment in
the 25 Hz Mode”.
3. Digital BETACAM Format
(When the Option HKSR-5002 is Installed)
n
When performing this adjustment continiously from “2.
HDCAM Format”, start this adjustment from step 2.
Alignment tape: for 29.97 Hz mode: ZR5-1
for 25 Hz mode: ZR5-1P
Playback system adjustment
1. Activate the ALT MAINTENANCE menu, and
display the RF ADJUST menu.
(HOME menu
→
[SFT]
+
[DIAG]
→
[SFT]
+
[F8]
→ [ALT] → [F7] →
RF ADJUST menu)
(For the RF ADJUST menu, refer to Section 3-4-5.)
2. Press the
[F1]
(FMT SEL) key several times to select
the DIGITAL BETACAM. When performing this
adjustment continuously from “2. HDCAM Format”,
press the
[F2]
(FMT SEL) key several times and
perform step 4 and later.
3. Press the
[F2]
(RF ALL ADJ) key to display the RF
ALL ADJUST menu.
4. Insert the alignment tape, then rewind it to the tape
beginning.
5. To execute the automatic adjustments, press the
[SET]
key.
.
After 5 minutes, the adjustments are completed, then
the message [NG List : Total 0] is displayed.
Saving the Data
n
Do not save the adjustment data if any automatic adjust-
ment was not completed properly.
6. Press the
[F1]
(NVRAM CTL) key to display the NV-
RAM CONTROL menu.
7. Select the “SAVE ALL DATA” by pressing the cursor
keys, then press the
[F10]
(EXIT) key to saving data.
.
The message “Save Complete” will be displayed
when this data save is completed normally.
8. Eject the alignment tape.
9. Exit the maintenance mode, and perform the “4.
Adjustment in the 25 Hz Mode”.
4. Adjustment in the 25 Hz Mode
1. Set the system to the 25 Hz mode referring to Section
8-1-3.
2. Perform the Itemized Digital Format RF System
Adjustments for each format in the 25 Hz mode.
3. Reset the system to the 29.97 Hz mode referring to
Section 8-1-3.