3-35
SRW-5000/5500
[F2]
(HDCAM DT) Key
Performs the operation checks of the DT heads for the HDCAM and Digital BETA-
CAM format playback.
n
This check requires the alignment tape HR5-1A.
Cue up the alignment tape to the time code 00:10:00:00 in advance.
When using the alignment tape not located to the time code 00:10:00:00, exit the
maintenance mode and cue it up. Then eject the alignment tape once.
Execution Procedure
1.
On the DT/SAT CHECK menu, press the
[F2]
(HDSR DT) key to display the
HDSR DT CHECK menu.
2.
Press the
[SET]
key.
3.
Insert the alignment tape HR5-1A located to the time code 00:10:00:00.
.
When the alignment tape is inserted, the check starts automatically. The
message “Auto Checking...” is displayed during check.
4.
Confirm the result of the check.
The message “Auto Adjust Complete” will be displayed and the alignment tape
will be ejected automatically when the check is completed normally.
n
If “Auto Adjust Failure” is displayed, refer to “If the check failed”.
5.
Press the
[F10]
(EXIT) key to exit the menu.
If the check failed:
If “Auto Adjust Failure” is displayed during the check, check the following:
1.
Check the bimorph driving circuit on the DT-47 board.
2.
Check the bimorph driving control circuit on the SS-95 board.
3.
Check the signal transmission system (slip ring etc.).
F1
F2
F3
F4
DIAG
ALT
F5
F6
F7
F8
F9
F10
HDSR
DT
HDCAM
DT
EXIT
DT CHECK
HDCAM DT CHECK
Press SET key.
DT CHECK
SET ALIGNMENT TAPE
HR5-1A for HDCAM
DT CHECK
1. DT offset
Auto Checking. . .
2. DT gain
Auto Adjusting. . .
DT CHECK
1. DT offset
Auto Adjust Complete
CH1: 14 CH2: 13
2. DT gain
Auto Adjust Complete
CH1: 416 CH2: 417
2.
[SET]
3. Insert the
alignment tape