5-17
SRW-5000/5500
Brush slip ring assembly
Flexible board
DT-47 board
Tightening torque : 14.7
x
10
_
2
N
.
m {1.5 kgf
.
cm}
CN220
PSW2
x
16
.
Brush slip ring assembly
Mounting surface
(Wipe with a dry
cleaning cloth)
Contacting points
(Wipe with a dry
cleaning cloth)
Contacting points
(Wipe with a dry
cleaning cloth)
Contacting points
(Wipe with a dry
cleaning cloth)
Contacting points
(Wipe with a dry
cleaning cloth)
Installation
2. Cleaning
Wipe the brush slip ring assembly mounting
surface (shaded portion in the figure) and the
contacting points at the drum side with a dry
cleaning cloth.
n
Never apply the cleaning fluid to the contacting
points.
3. Attaching the Brush Slip Ring
Assembly
(1) Insert the two screws taken out in (3) of step
1 into the screw holes of the brush slip ring
assembly.
(2) Insert the brush slip ring assembly into the
upper drum assembly as shown in the figure.
(3) Tighten the two screws alternately while
pushing both sides of the flange equally from
above.
Tightening torque: 14.7
x
10
–2
N
.
m
{1.5 kgf
.
cm}
n
Never apply excessive force to the cover.
(4) Connect the flexible board into the connector
CN220 on the DT-47 board, then lock.
Cleaning
Attach the Brush Slip Ring Assembly