3-95
SRW-5000/5500
NVRAM
CTL
FMT
SEL
EXIT
VCA
[HDCAM-SR]
To adjust all channels,
press F6 key.
To select the channel,
press F7 key.
HDCAM-SR FORMAT RF ADJUST
ALL CH
ADJ
CH
SEL
DIAG
F1
F2
F3
F4
ALT
F5
F6
F7
F8
F9
F10
3.
Cue up an alignment tape of the selected format to the tape beginning, and insert it.
When
[F5]
(REC ADJ) is selected, insert a recordable cassette tape.
n
.
The adjustment cannot be performed correctly with a non-specified cassette tape. Be sure to use the
following alignment tapes:
Selected format
HDCAM SR
HDCAM
Digital BETACAM
(HKSR-5002 installed model only)
Alignment tape
HR5-1B
HR5-1A
ZR5-1 (59.94 Hz mode)
ZR5-1P (50 Hz mode)
.
Pay attention to the transport start position of the tape so that the end and beginning of the tape are
not detected during adjustment. If the cassette is forcibly ejected during the automatic adjustment,
the adjustment is cancelled, its result is detected, and the display returns to the initial window. The
minimum tape amount required for the normal automatic adjustment is shown in the following
table: however, the tape amount increases or decreases when the adjustment is abnormal.
Menu
Upper level: Normal adjustment time
Lower level: Tape amount required (Transport mode)
VCA ADJUST
About 10 min./ALL, about 25 sec./channel
Adjustment time (PLAY)
EQULZR ADJUST
About 12 min./ALL, about 30 sec./channel
Adjustment time (PLAY)
REC ADJUST
About 8 min./ALL, about 1 min./channel
Adjustment time (REC)
PLAY PLL ADJUST
About 12 min./ALL, about 30 sec./channel
Adjustment time (PLAY)
FWD PLL ADJUST
About 30 sec./ALL, about 30 sec./channel
Adjustment time (FWD)
REV PLL ADJUST
About 30 sec./ALL, about 30 sec./channel
Adjustment time (REV)
AD GAIN ADJUST
About 10 min./ALL, about 25 sec./channel
Adjustment time (PLAY)