Sony SRW-5000, Maintenance Manual, Page: 405 / 438

8-7
SRW-5000/5500
8-3-4. Servo Continuity Automatic
Adjustment
m
.
The automatic adjustment does not use any alignment
tape.
.
When performing this adjustment continuously from
Section 8-3-2 or 8-3-3, start this adjustment from step 2.
1. Activate the ALT MAINTENANCE menu, and
display the SERVO ADJUST menu.
(HOME menu
→ [SFT]
+
[DIAG] → [SFT]
+
[F8]
→
[ALT]
→
[F4]
→
SERVO ADJUST menu)
(For the SERVO ADJUST menu, refer to Section 3-4-
2.)
2. Press the
[F2]
(AUTO ADJ) key to display the AUTO
ADJUST menu.
3. Press the
[SET]
key.
.
Continuity automatic adjustment is executed auto-
matically. (about 3 and a half minutes)
.
The message “Auto Adjust Complete” will be
displayed when this automatic adjustment is com-
pleted normally.
Saving the Data
4. Press the
[F1]
(NVRAM CTL) key to display the NV-
RAM CONTROL menu.
5. Select the “SAVE ALL DATA” by pressing the cursor
keys, then press the
[F10]
(EXIT) key to saving data.
.
The message “Save Complete” will be displayed
when this data save is completed normally.
6. Press the
[F10]
(EXIT) key two times to exit the
SERVO ADJUST menu.
7. When the next adjustment (Section 8-3-5) is not
performed, exit the maintenance mode.
8-3-5. HDCAM SR DT System Adjustment
Alignment tape: HR5-1B
m
.
Cue up the alignment tape to the time code 00:10:00:00
in advance.
When using the alignment tape not located to the time
code 00:10:00:00, exit the maintenance mode and cue it
up. Then eject the alignment tape once.
.
When performing this adjustment continuously from
Section 8-3-4, start this adjustment from step 2.
1. Activate the ALT MAINTENANCE menu.
(HOME menu
→
[SFT]
+
[DIAG]
→
[SFT]
+
[F8]
→ [ALT] →
ALT MAINTENANCE menu)
2. Press the
[F5]
(DT/SAT ADJ) key.
(For the DT/SAT ADJUST menu, refer to Section 3-4-
3.)
3. Press the
[F2]
(HDSR DT) key to display the HDSR
DT ADJUST menu.
4. Press the
[SET]
key.
5. Insert the alignment tape located to the time code
00:10:00:00.
.
Adjustment is executed automatically when the
alignment tape is inserted.
.
The message “Auto Adjust Complete” will be
displayed and the alignment tape will be ejected
automatically when this automatic adjustment is
completed normally.
Saving the Data
6. Press the
[F1]
(NVRAM CTL) key to display the NV-
RAM CONTROL menu.
7. Select the “SAVE ALL DATA” by pressing the cursor
keys, then press the
[F10]
(EXIT) key to saving data.
.
The message “Save Complete” will be displayed
when this data save is completed normally.
8. When the next adjustment (Section 8-3-6) is not
performed, exit the maintenance mode.