Remote Commands for Analog Demodulation Measurements
R&S
®
FSW-K7
336
User Manual 1173.9240.02 ─ 17
1 = origin of coordinate system (x1 = 0, y1 = 0)
2 = end point of system (x2 = 100, y2= 100)
3 = zoom area (e.g. x1 = 60, y1 = 30, x2 = 80, y2 = 75)
Suffix:
<zoom>
.
1...4
Selects the zoom window.
Parameters:
<x1>,<y1>,
<x2>,<y2>
Diagram coordinates in % of the complete diagram that define
the zoom area.
The lower left corner is the origin of coordinate system. The
upper right corner is the end point of the system.
Range:
0 to 100
Default unit: PCT
Manual operation:
See
DISPlay[:WINDow<n>]:ZOOM:MULTiple<zoom>:STATe
<State>
This command turns the mutliple zoom on and off.
Suffix:
<zoom>
.
1...4
Selects the zoom window.
If you turn off one of the zoom windows, all subsequent zoom
windows move up one position.
Parameters:
<State>
ON | OFF
*RST:
OFF
Manual operation:
See
See
See
"Deactivating Zoom (Selection mode)"
11.8.4 Configuring an Analysis Interval and Line (MSRA mode only)
In MSRA operating mode, only the MSRA Master actually captures data; the MSRA
applications define an extract of the captured data for analysis, referred to as the
analysis interval
. The
analysis line
is a common time marker for all MSRA applica-
tions.
Analyzing Results
