Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 64 / 314

Basic Operation
R&S
®
Cable Rider ZPH
29 User Manual 1321.0950.02 ─ 03
The Invalid trace indicator is displayed below the S11 result format and calibration sta-
tus.
For information of result format and calibration status, see Chapter 7.1, "Performing
Cable and Antenna Measurements" , on page 102 and Chapter 7.1.6.1, "Calibration
States" , on page 110.
For information of markers, display line and limit lines, see Chapter 7.3, "Analyzing
Measurement Results" , on page 124.
4.1.4 Parameter View
The "Parameter view" contains the important hardware setting parameters used in the
measurement.
It is located at the right side and bottom section of the screen layout. See Figure 4-1 .
You can select any parameter in the "Parameter view" to adjust the configurations of
the hardware settings. See details of each of the parameter in
Chapter 7.2.2, "Config-
uring the Horizontal Axis" , on page 117 and Chapter 7.2.3, "Configuring the Vertical
Axis" , on page 121.
Parameter Description
"Center", "Start", "Stop" Function-specific displays depending on the softkey
indicated in the softkey label. It is used to configure
one of the following:
●
center frequency, start or stop frequency for the
measurement.
●
start or stop cable length for measurement.
See
Chapter 7.2.2, "Configuring the Horizontal
Axis" , on page 117.
"Span" Configure the frequency span of the measurement.
See Chapter 7.2.2.1, "Setting the Frequency Range
for DTF Measurements" , on page 117.
Time & Date Display time and date of the instrument. This is a
read-only field.
See Chapter 4.2.3, "Configuring Date and Time" ,
on page 35 and "Setting the date format"
on page 37.
Screen Layout and Elements