Cable and Antenna Test Mode
R&S
®
Cable Rider ZPH
101
User Manual 1321.0950.02 ─ 03
FSH-Z28/Z29, order number 1300.7810.03 / 1300.7610.03 or R&S ZN-Z103 order
number 3586.9392.00) and the cable under test. See
Cable and antenna tests also require a signal source which is already part of the R&S
Cable Rider ZPH hardware. The signal source transmits a reference signal through the
internal VSWR bridge to the test port.
1. Connect the RF cable to the RF input.
2. Connect the test cable to the RF cable.
By default, the R&S Cable Rider ZPH is in the CAT mode after you have turned it on.
To switch to the CAT mode from another operating mode, proceed as follows.
1. Press the MODE key.
2. Select the "Antenna & Cable" softkey.
The R&S Cable Rider ZPH starts the antenna and cable test (CAT) mode.
Figure 7-2: Screen layout of cable and antenna test mode
1 = Measurement type
2 = Cable model
3 =
4 =
5 = Status line: (S-matrix, calibration status, measurement format)
6 =
7 = Delta marker
8 = Marker
9 =
10 = Cable start length
11 = Cable stop length
