Working with the Measurement Wizard
R&S
®
Cable Rider ZPH
94
User Manual 1321.0950.02 ─ 03
Figure 6-4: Perform wizard measurement dialog box
1 = Image of a measurement step defined in the R&S InstrumentView software package.
2 = Wizard message box
3 = See
1. Select the "Start Meas" softkey.
If you have not yet calibrated the R&S Cable Rider ZPH for the measurement, it
asks you to perform the calibration routine. The stages of the calibration depend on
the defined calibration routine. See
Chapter 7.1.6, "Calibrating Measurements"
After having successfully calibrated the R&S Cable Rider ZPH, it starts to go
through the measurements that are part of the measurement wizard set. The
sequence of the measurements is defined in the R&S InstrumentView.
Before the start of each measurement, the R&S Cable Rider ZPH displays a mas-
sage "Preparing New Measurement" in the wizard message box.
The message box contains information and instructions on how to prepare and per-
form the measurement that you have defined in the R&S InstrumentView software.
2. At each measurement step, you have several options:
● Select the "Continue" softkey.
The R&S Cable Rider ZPH finishes the current measurement and opens the
measurement wizard dialog box. See
Performing and Configuring Measurements
