Power Meter
R&S
®
Cable Rider ZPH
141
User Manual 1321.0950.02 ─ 03
Figure 8-2: Screen layout of the directional power mode
1 = Selected transmission standard
2 = Connected power sensor model
3 = Reference for relative power measurements
4 = Power offset
5 = Readout of the forward power
6 = Analog readout of the forward power
7 = Readout of the matching value
8 = Analog readout of the matching value
9 = Measurement frequency
10 = Configuration overview icon
11 = Directional power sensor "MEAS" softkey menu
8.2.1 Connecting a Directional Power Sensor
The R&S Cable Rider ZPH controls and powers the directional power sensors via a
special interface on the top of the instrument.
Connect the power sensor cable via the USB to binder adapter to the USB port of R&S
Cable Rider ZPH. The power sensor itself is located between the source and the load
of the test setup.
For the test setup of the directional power sensor, see
If the R&S Cable Rider ZPH recognizes a power sensor, it sets up a connection via the
interface and after a few seconds shows the results. It displays the type of the power
sensor in the display header. If an error occurs, the R&S Cable Rider ZPH shows a
corresponding message.
For more information, see
Chapter 8.1.1, "Connecting a Power Sensor"
Using a Directional Power Sensor
