Remote Commands
R&S
®
Cable Rider ZPH
201
User Manual 1321.0950.02 ─ 03
Parameters:
<Threshold>
Numeric value whose unit depends on the unit you have cur-
rently selected for the vertical axis.
Default unit: dBm
Example:
CALC:LIM:LOW:THR -10DBM
Defines a threshold of -10 dBm.
CALCulate<1...2>:LIMit<1...2>:UPPer:THReshold
<Threshold>
This command defines the level of an upper threshold limit line.
The numeric suffix at CALCulate is irrelevant for this command. The numeric suffix at
LIMit selects the limit line.
Suffix:
<1...2>
.
1...2
<1...2>
1...2
Parameters:
<Threshold>
Numeric value whose unit depends on the unit you have cur-
rently selected for the vertical axis.
Default unit: dBm
Example:
CALC:LIM:UPP:THR -10DBM
Defines a threshold of -10 dBm.
11.6.2.7
Configuring and Using Measurement Functions
This chapter provides information on how to configure one-port measurements with the
signal source. The structure follows the order of the actual operation sequence used
when performing a measurement:
To perform the actual measurement, use the commands described in
ter 11.6.2.3, "Performing and Triggering Measurements"
●
"Selecting the Cable Characteristics"
●
"Selecting the Measurement Mode"
●
"Selecting the Measurement Format"
●
"Reading Out Measurement Results"
●
●
Selecting the Cable Characteristics
The following commands define the cable characteristics for the cable you are testing.
List of commands
●
CALCulate<1...2>:DTF:CABLe:PRESet
Remote Control - Commands
