Remote Commands
R&S
®
Cable Rider ZPH
195
User Manual 1321.0950.02 ─ 03
Parameters:
<State>
ON | OFF
*RST:
OFF
Example:
See
CALCulate<1...2>:MARKer<1...6>:X:
CALCulate<1...2>:MARKer<1...6>:X:SLIMits<1...2>:LEFT
<SearchLimit>
This command defines the left limit of the marker search range.
To use the command, you first have to turn on search limits with
CALCulate<1...2>:MARKer<1...6>:X:SLIMits<1...2>[:STATe]
The numeric suffix at CALCulate selects the trace. The numeric suffix at MARKer
selects the marker.
Parameters:
<SearchLimit>
Sets the left marker search limit.
The unit in the spectrum analyzer mode depends on the mea-
surement, e.g. Hz for measurements in the frequency domain
and seconds for measurements in the time domain.
Range:
Maximum span.
*RST:
– (is set to the left diagram border when switching
on search limits)
Default unit: GHz
Example:
See
CALCulate<1...2>:MARKer<1...6>:X:
CALCulate<1...2>:MARKer<1...6>:X:SLIMits<1...2>:RIGHt
<SearchLimit>
This command defines the right limit of the marker search range.
To use the command, you first have to turn on search limits with
CALCulate<1...2>:MARKer<1...6>:X:SLIMits<1...2>[:STATe]
The numeric suffix at CALCulate selects the trace. The numeric suffix at MARKer
selects the marker.
Parameters:
<SearchLimit>
Sets the right marker search limit.
The unit depends on the measurement, e.g. Hz for measure-
ments in the frequency domain and seconds for measurements
in the time domain.
Range:
Maximum span.
*RST:
– (is set to the right diagram border when switching
on search limits)
Default unit: GHz
Remote Control - Commands
