Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 245 / 314

Remote Commands
R&S
®
Cable Rider ZPH
210 User Manual 1321.0950.02 ─ 03
11.6.3.1 Setting the Frequency
The following chapter describes commands necessary to define frequency settings.
List of commands
●
[SENSe:]PMETer:FREQuency
on page 210
[SENSe:]PMETer:FREQuency <Frequency>
This command sets the frequency of the power sensor.
Parameters:
<Frequency> Specified in the data sheet.
Default unit: GHz
Example: PMET:FREQ 500 MHZ
Sets the power sensor's frequency to 500 MHz.
11.6.3.2 Configuring Power Level Readout
The following chapter describes commands that configure the power level readout.
List of commands
●
CALCulate<1...2>:PMETer:RELative[:MAGNitude]
on page 210
●
CALCulate<1...2>:PMETer:RELative[:MAGNitude]:AUTO
on page 210
●
CALCulate<1...2>:PMETer:RELative[:MAGNitude]:OFFSet
on page 211
●
UNIT<1...2>:PMETer:POWer
on page 211
CALCulate<1...2>:PMETer:RELative[:MAGNitude] <RefLevel>
This command sets the reference value for relative measurements.
The numeric suffix at CALCulate is irrelevant for this command.
Parameters:
<RefLevel> Default unit: dBm
Example: CALC:PMET:REL 30
The reference value to 30 dBm.
CALCulate<1...2>:PMETer:RELative[:MAGNitude]:AUTO <ONCE>
This command sets the current measurement result as the reference level for relative
measurements.
This command is an event and therefore has no *RST value and no query.
The numeric suffix at CALCulate is irrelevant for this command.
Parameters:
<ONCE> ONCE
Remote Control - Commands