Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 127 / 314

Working with the Measurement Wizard
R&S
®
Cable Rider ZPH
92 User Manual 1321.0950.02 ─ 03
Measurement parameters Descriptions
Comments Comments about the measurement, e.g. the external con-
ditions during the measurement.
GPS Position Displays the GPS information. See Chapter 4.2.2, "Using
the GPS Receiver" , on page 33.
Cable Definition Use Wizard
Cable Set-
tings Select the usage of cable characteristics as defined in the
measurement set.
Select "On" to use the predefined cable characteristics or
"Off" to re-define the cable model and cable length in R&S
Cable Rider ZPH. In the case, if "On" is selected, the
parameters below will be locked.
Cable Model Cable model that you perform the measurement on. You
can define a cable model with the R&S Cable Rider ZPH
software, but can also change the cable model on short
notice, if necessary. See
Chapter 7.2.1.3, "Creating a
Cable Model" , on page 115.
Clear Cable
Model Deactivates the currently active cable model. See Chap-
ter 7.2.1.2, "Clear Cable Model" , on page 115.
Cable Length Length of the cable that you perform the measurement on.
Cable Settings Default Cali-
bration Calibration that was defined when creating the wizard set
in the R&S InstrumentView software.
Use Stored
Calibrations If set to "On", the wizard uses the calibration stored in the
R&S Cable Rider ZPH. If set to "Off", the wizard uses the
calibration defined in the R&S InstrumentView software.
Measurement specification
The measurement specification dialog box displays the measurement step sequences
and the individual performed measurement status. See
Figure 6-3 .
► Select the "Meas Spec" softkey.
The R&S Cable Rider ZPH opens the "Meas Spec" dialog box.
Performing and Configuring Measurements