Working with the Measurement Wizard
R&S
®
Cable Rider ZPH
95
User Manual 1321.0950.02 ─ 03
Figure 6-5: Measurement wizard dialog
–
Select the "Next Meas" softkey to proceed to the next measurement step in
the measurement sequence.
–
Select the "Repeat Meas" softkey if the result does not match your expect-
ation and you want to validate the result again.
–
Select the "Interrupt" softkey if the result does not match your expectation
and you want to find the origin of the problem by using a different settings
or measurement than those defined in the wizard.
–
Select the "Finish Wizard" softkey to end the measurement sequence.
–
Select the "Cancel" softkey if at any time the result does not match your
expectation and you want to abort the measurement.
The R&S Cable Rider ZPH prompts you to save measurement result and
exit the wizard measurement.
● Select the "Interrupt" softkey.
The R&S Cable Rider ZPH opens the wizard interrupt dialog box.
There are three selections in the wizard interrupt dialog box, you can either:
–
Select the "Leave Menu" softkey to proceed and perform the necessary
reconfiguring of the measurement. The R&S Cable Rider ZPH goes to the
current measurement environment which you can analyze the measure-
ment settings and make the necessary reconfiguration on the measure-
ments.
After you have completed the reconfiguration on the measurement, press
WIZARD key to return back to the wizard interrupt dialog box
–
Select the "Resume Sequence" softkey to resume back to the measure-
ment.
–
Select the "Cancel" softkey to abort the wizard measurement.
● Select the "Skip" softkey.
The R&S Cable Rider ZPH skips a single measurement step and continue the
subsequent measurement step.
Performing and Configuring Measurements
