Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 214 / 314

Remote Commands
R&S
®
Cable Rider ZPH
179 User Manual 1321.0950.02 ─ 03
CALCulate<1...2>:DTF:DISTance:STOP <DtfDistanceStop>
This command defines the end point of the cable measurement.
The numeric suffix at CALCulate is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<DtfDistanceStop> Numeric value in the range from 3 m (10 ft) to 1500 m (4921 ft)
The unit is either meter or feet, depending on your selection.
*RST:
1500 m (4921 ft)
Default unit: m
Example: CALC:DTF:DIST:STOP 500m
Sets the end point of the measurement to 500 m.
11.6.2.2 Configuring the Vertical Axis
The following commands configure the vertical (level) axis and level parameters of the
active display.
Commands independent of the operating mode
Note that some of the commands for configuring the vertical axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
●
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
on page 179
●
DISPlay<1...2>:LOSS:REFerence
on page 180
●
DISPlay<1...2>:LOSS:REFerence:POSition
on page 180
●
DISPlay<1...2>:LOSS:Y:SCALe
on page 180
●
DISPlay<1...2>:MAGNitude:REFerence
on page 181
●
DISPlay<1...2>:MAGNitude:REFerence:POSition
on page 181
●
DISPlay<1...2>:MAGNitude:Y:SCALe
on page 181
●
DISPlay<1...2>:MAGNitude:Y:SPACing
on page 182
●
DISPlay<1...2>:VSWR:Y:SCALe:MINimum
on page 182
●
DISPlay<1...2>:VSWR:Y:SCALe:MAXimum
on page 183
●
DISPlay<1...2>:VSWR:Y:SCALe
on page 183
DISPlay<1...2>[:WINDow]:TRACe<1...2>:Y[:SCALe]:ADJust
This command automatically scales the vertical axis for optimum display results.
This command is an event and therefore has no query and no *RST value.
Remote Control - Commands