Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 211 / 314

Remote Commands
R&S
®
Cable Rider ZPH
176 User Manual 1321.0950.02 ─ 03
11.6.2 Remote Commands of the Cable and Antenna Analyzer
This section provides a detailed description of all remote control commands required to
configure and perform measurements in Cable and Antenna Test (CAT) mode.
● Configuring the Horizontal Axis .............................................................................176
● Configuring the Vertical Axis .................................................................................179
● Performing and Triggering Measurements ............................................................183
● Working with Traces ..............................................................................................185
● Using Markers .......................................................................................................189
● Using Limit Lines ...................................................................................................196
● Configuring and Using Measurement Functions ...................................................201
11.6.2.1 Configuring the Horizontal Axis
The following commands configure the horizontal (frequency) axis of the active display.
Commands independent of the operating mode
Note that some of the commands for configuring the horizontal axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
●
[SENSe:]FREQuency:CENTer
on page 176
●
[SENSe:]FREQuency:CENTer:STEP
on page 177
●
[SENSe:]FREQuency:CENTer:STEP:LINK
on page 177
●
[SENSe:]FREQuency:SPAN
on page 177
●
[SENSe:]FREQuency:SPAN:AUTO
on page 177
●
[SENSe:]FREQuency:STARt
on page 178
●
[SENSe:]FREQuency:STOP
on page 178
●
CALCulate<1...2>:DTF:DISTance:STARt
on page 178
●
CALCulate<1...2>:DTF:DISTance:STOP
on page 179
[SENSe:]FREQuency:CENTer <CenterFrequency>
This command defines the center frequency of the R&S Cable Rider ZPH.
In spectrum analyzer mode, the command also defines the measuring frequency for
time domain measurements (span
= 0).
Parameters:
<CenterFrequency> Range: Depends on the operating mode and is specified in
the data sheet.
*RST: fmax /2 with fmax = maximum frequency
Default unit: MHz
Example: FREQ:CENT 100MHz
Defines a center frequency of 100 MHz.
Remote Control - Commands