Remote Commands
R&S
®
Cable Rider ZPH
184
User Manual 1321.0950.02 ─ 03
Parameters:
<State>
ON | OFF
ON
Selects continuous sweeps.
OFF
Selects single sweep.
*RST:
ON
Example:
INIT:CONT OFF
Turns on single sweep mode.
[SENSe:]SWEep:POINts
<NrofPoints>
This command queries the number of measurement points in a single sweep.
This command is a query and therefore has no *RST value.
Parameters:
<NrofPoints>
Returns the number of sweep points.
Example:
SWE:POIN?
Returns the number of sweep points.
Triggering Measurements
The following commands set up trigger conditions if you are using a trigger for the
measurement.
List of commands
●
TRIGger[:SEQuence]:HOLDoff[:TIME]
●
●
TRIGger[:SEQuence]:HOLDoff[:TIME]
<TriggerDelay>
This command defines the length of the trigger delay.
Parameters:
<TriggerDelay>
Range:
0 s to 100 s
*RST:
0 s
Default unit: s
Example:
TRIG:HOLD 500us
Sets the trigger delay to 500 µs.
TRIGger[:SEQuence]:SLOPe
<TriggerSlope>
This command selects the slope of the trigger signal.
The trigger slope applies to all trigger sources.
Remote Control - Commands
