Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 244 / 314

Remote Commands
R&S
®
Cable Rider ZPH
209 User Manual 1321.0950.02 ─ 03
Parameters:
<State> ON | OFF
ON
DTF list turns on.
OFF
DTF list turns off.
Example: CALC:TRAN:DTF:PEAK ON
Turns on the DTF peak list.
CALCulate<1...2>:TRANsform:DTFault:PEAK:THReshold <Threshold>
This command defines the threshold for the DTF list.
All values that exceed the threshold are in the DTF list. You can query the list with
CALCulate<1...2>:TRANsform:DTFault:PEAK:DATA<1...10>?
on page 208.
The numeric suffix at CALibration is irrelevant for this command.
Suffix:
<1...2>
.
1...2
Parameters:
<Threshold> The unit depends on the measurement format.
Example: CALC:TRAN:DTF:PEAK:THR -20
Sets the threshold to -20 dB.
11.6.3 Remote Commands of the Power Meter
The chapter provides information on remote commands that configure and perform
power measurements with the power sensor. These commands are available in power
meter mode only.
Availability of remote commands for Power Sensor measurements
Note that the listed remote commands take effect only if a power sensor is connected.
Contents
●
Chapter 11.6.3.1, "Setting the Frequency" , on page 210
●
Chapter 11.6.3.2, "Configuring Power Level Readout" , on page 210
●
Chapter 11.6.3.3, "Defining the Measurement Time" , on page 211
●
Chapter 11.6.3.4, "Zeroing of the Power Sensor" , on page 212
●
Chapter 11.6.3.5, "Forward Power Display" , on page 212
●
Chapter 11.6.3.6, "Defining the Video Bandwidth" , on page 213
●
Chapter 11.6.3.7, "Reading Out Measurement Results" , on page 213
●
Chapter 11.6.3.8, "Selecting a Telecommunication Standard" , on page 214
Remote Control - Commands