Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 101 / 314

Basic Operation
R&S
®
Cable Rider ZPH
66 User Manual 1321.0950.02 ─ 03
After zeroing is done, the R&S Cable Rider ZPH displays the message "Power sensor
zero done" and again shows the power sensor softkey menu.
► Connect the R&S FSH-Z14 or R&S FSH-Z44 between the source and the load.
The R&S Cable Rider ZPH displays the measured forward power in dBm and the
SWR of the load. See
Figure 8-2
To get the best results, you should also define the frequency of the signal. For more
information, see
Chapter 4.6.1.1, "Measuring the Power with a Power Sensor" ,
on page 62.
4.7 Saving and Recalling Results and Settings
Storage device
If both USB flash drive and micro-SD card are connected to the instrument, the USB
flash drive takes precedent over SD card as a storage device.
If both storage devices are not connected, the internal memory of the instrument is
used for storage.
The R&S Cable Rider ZPH can store measurement results and settings in the internal
memory, removable micro-SD card or on a USB flash drive via the USB interface.
Results and settings are always stored together, allowing them to be interpreted in
context when recalled. The R&S Cable Rider ZPH can store at least 100 data records
in the internal memory which are differentiated by their names.
The R&S Cable Rider ZPH provides two USB ports and one micro-SD card slot .
For more information on saving measurement results and settings, see Chapter 5.8.1,
"Saving Datasets" , on page 83.
For more information on recalling measurement results and settings, see Chap-
ter 5.8.2, "Restoring Datasets" , on page 86.
Saving and Recalling Results and Settings