Rohde & Schwarz Cable Rider ZPH, User Manual

Page: 260 / 314

Remote Commands
R&S
®
Cable Rider ZPH
225 User Manual 1321.0950.02 ─ 03
11.6.7.2 Controlling the GPS Receiver
This chapter describes all commands that control the GPS receiver.
List of commands
●
SYSTem:POSition:ALTitude?
on page 225
●
SYSTem:POSition:GPS:CONNected?
on page 225
●
SYSTem:POSition:GPS:CORRection:FREQuency?
on page 225
●
SYSTem:POSition:GPS:QUALity?
on page 226
●
SYSTem:POSition:GPS:SATellites?
on page 226
●
SYSTem:POSition:GPS[:STATe]
on page 226
●
SYSTem:POSition:LATitude?
on page 226
●
SYSTem:POSition:LONGitude?
on page 226
●
SYSTem:POSition:VALid?
on page 227
SYSTem:POSition:ALTitude?
This command queries the altitude of the current position of the R&S Cable Rider ZPH.
Example: SYST:POS:ALT?
Return value would be, for example, 554.1.
Usage: Query only
SYSTem:POSition:GPS:CONNected?
This command queries if the R&S Cable Rider ZPH is currently connected to the GPS
receiver.
Example: SYST:POS:GPS:CONN?
Usage: Query only
SYSTem:POSition:GPS:CORRection:FREQuency?
This command queries the frequency correction factor.
The R&S Cable Rider ZPH calculates this factor from a reference signal provided by
the GPS receiver. The reference signal is used to determine the deviation of the inter-
nal clock of the instrument. The deviation can be turned into a correction factor for the
measured frequency.
Example: SYST:POS:GPS:CORR:FREQ?
Queries the frequency correction factor.
Usage: Query only
Remote Control - Commands