![background image](http://html1.mh-extra.com/html/omron/sysmac-cs-series/sysmac-cs-series_reference-manual_742030247.webp)
207
Sequence Control Instructions
Section 3-5
Description
END(001) completes the execution of a program for that cycle. No instructions
written after END(001) will be executed.
Execution proceeds to the program with the next task number. When the pro-
gram being executed has the highest task number in the program, END(001)
marks the end of the overall main program.
Precautions
Always place END(001) at the end of each program. A programming error will
occur if there is not an END(001) instruction in the program.
3-5-2
NO OPERATION: NOP(000)
Purpose
This instruction has no function. (No processing is performed for NOP(000).)
Ladder Symbol
There is no ladder symbol associated with NOP(000).
Variations
Applicable Program Areas
Description
No processing is performed for NOP(000), but this instruction can be used to
set aside lines in the program where instructions will be inserted later. When
the instructions are inserted later, there will be no change in program
addresses.
Flags
No flags are affected by NOP(000).
I/O refreshing
Task 1
Task 2
Task n
Program Z
Program A
Program B
To the next task number
To the next task number
End of the main program
Variations
Executed Each Cycle for ON Condition
NOP(000)
Immediate Refreshing Specification
Not supported
Block program areas
Step program areas
Subroutines
Interrupt tasks
OK
OK
OK
OK
Summary of Contents for SYSMAC CS Series
