Omron SYSMAC CS Series, Reference Manual, Page: 1204 / 1405

1164
Failure Diagnosis Instructions
Section 3-30
2. When the rightmost 3 digits of C specify an FAL number of 00A hex (10),
the corresponding Executed FAL Number Flag (A36010) will be turned
ON, the corresponding error code (410A) is written in A400, and the FAL
Error Flag (A40215) is turned ON.
Logic Diagnosis Function (C=000A)
Since the leftmost digit of C is 0 (bit address output mode) the PLC memory
address of CIO 010000 is output to D00303 and D00302. (CIO 010000 is on a
higher instruction line than CIO 010003.)
Logic Diagnosis Function (C=800A)
Since the leftmost digit of C is 8 (bit address and message output mode) the
address of CIO 010000 (010000) is output to D00302 through D00304 in
ASCII.
Setting the Monitoring Time with the Teaching Function
The monitoring time can be set automatically with the teaching function when
a word address has been specified for T.
R:
Not used.
Not used.
Bit Address Found Flag
1: Bit address found
FAL number = 10
Diagnostic output mode = 0 (bit address output)
Input type
0: Normally open
Contains internal I/O memory address.
R+1: D00301
R: D00300
R+2: D00302
R+3: D00303
R+4: D00304
R+5: D00305
R+6: D00306
R+7: D00307
R+8: D00308
R+9: D00309
30
30
30
2D
54
25
25
00
31
30
30
30
25
F4
00
00
R+10: D00310
00
00
FAL number = 10
Diagnostic output mode = 8 (bit address and message output)
Bit Address Found Flag
1: Bit address found
Input type
0: Normally open
Contains bit address in ASCII.
(010000 is converted to ASCII.)
User-set FAL error message output to a
Peripheral Device by the time monitoring
function. The Peripheral Display will show
the following: 010000-0 ERROR.
Not used.