Omron CJ1W-C113 - REV 02-2008, Operation Manual

Page: 354 / 406

327
Error Code Lists Section 11-5
Positioning
sequences Sequence data
error 3000
to
3099 One of the following errors occurred in
the positioning sequence:
The completion code is not in the range
0 to 6.
The initial speed number is not in the
range 00 to 99.
The acceleration time number is not in
the range 0 to 9.
The deceleration time number is not in
the range 0 to 9.
The target speed number is not in the
range 00 to 99.
The dwell time number is not in the
range 00 to 19.
One of the following errors occurred in
the axis designation:
The Y, Z, or U axis was specified for a 1-
axis PCU.
The Z or U axis was specified for a 2-
axis PCU.
More than one axis is specified for inter-
rupt feeding or speed control, or all axis
designation settings are set to 0.
(The last two digits of the code indicate
the position data number (00 to 99)
where the error occurred.)
Transfer the data
again after
checking and
correcting it. When this error
occurs during
data transfer, all
data (including
the data with the
error) specified
for transfer will
be lost.
All operating
axes will be
decelerated to a
stop.
Dwell times Dwell time error 4001
to
4019 These codes indicate that a dwell time
is outside the settable range (0 to
9.99 s).
(The last two digits of the code indicate
the dwell time number (00 to 19) where
the error occurred.)
Item Name Code Cause Clearing
method
Operation after
error