Mitsubishi Electric MELSEC iQ-R Series, Programming Manual

Page: 1661 / 2110

19 CC-LINK INSTRUCTIONS
19.6 Writing Data to the Automatic Update Buffer
1659
19
19.6
Writing Data to the Automatic Update Buffer
G(P).RITO
These instructions write data to the automatic update buffer or random access buffer. The instructions can be used for
communications with a module having the automatic update buffer such as AJ65BT-R2N.
■
Execution condition
Setting data
■
Description, range, data type
*1 Value that was set in the CC-Link configuration window of the engineering tool.
*2 When specifying setting data by using a label, define an array to secure enough operation area and specify an element of the array
label.
Ladder ST
ENO:=G_RITO(EN,U,s,n,d1,d2);
ENO:=GP_RITO(EN,U,s,n,d1,d2);
FBD/LD
Instruction Execution condition
G.RITO
GP.RITO
Operand Description Range Data type Data type (label)
(U) Start I/O number (first three digits in four-digit
hexadecimal representation) of a module 00H to FEH 16-bit unsigned binary ANY16
(d1) If data is written to an automatic update buffer: Station
number of target station 1 to 64 16-bit unsigned binary ANY16
If data is written to a random access buffer: Specifies the
random access buffer. 00FFH 16-bit unsigned binary ANY16
(d2) Offset value from the start of the automatic update or
random access buffer that has been assigned to the
target station 0 to parameter set value
*1
16-bit unsigned binary ANY16
(s) Start device for storing the data to be written

Device name ANY16
*2
(n) Number of write points 1 to 4096 16-bit unsigned binary ANY16
EN Execution condition

Bit BOOL
ENO Execution result  Bit BOOL
RnCPU RnENCPU
RnSFCPU RnSFCPU RnPCPU RnPCPU
(Standard) (Safety) (Redundant) (Process)
(U) (d1) (d2) (s) (n)
EN ENO
U
s
n
d1
d2