GRAUPNER mx-24s, Programming Manual

Page: 49 / 216

49 Brief programming instructions
fl ight phase switches are defi ned in the » Phase assignment « menu.
Name: up to ten user-defi ned phase names are available in addition to sixteen standard names. The
additional names can be defi ned individually in the »
General basic settings « menu. The as-
signed names are shown in the basic display, and in all programs which are fl ight phase spe-
cifi c.
Fl.ph.Tim.: the switches for all these timers are assigned in the » Flight phase timers « menu.
Clk 1 … 3: can be set in the » Flight phase timers « menu as stopwatches or alarm timers.
Lap: in the basic display a “lap timer” appears next to the lap counter. Each press on the (momen-
tary) switch assigned in the “Lap time / elapsed time” line of the »
Flight phase timers « menu
increases the value of the lap counter display, records the intervening lap time, and fi nally re-
starts the lap timer. Time display up to 59.9 seconds in 1/10 second increments; after 60 se-
conds in min : sec.
“Time1”: records only those times for which the switch assigned in the “Lap time / time tab” line of the
»
Flight phase timers « menu is “closed”. The frequency of switch operations is shown in the
basic display. This counter fi eld is highlighted as soon as the switch for the Time1 timer is
“opened”, i. e. the timer is stopped.
“Time2”: this timer stores both the “off” and “on” times of the ON / OFF switch assigned in the “Lap time
/ time tab” line of the »
Flight phase timers « menu, i. e. each time the switch is operated the
timing restarts and the counter is incremented by 1.
Reading out the lap counter, Time1 or Time2 in the basic display:
Set the timer switches to OFF, or stop the timer with
ESC . The lap count or the counter of Time1 or Time2
is displayed highlighted on the screen. The individual times can now be read out using the rotary control. Fi-
nally press
CLEAR in order to reset the counter and the times.
Motor: this column only appears if you have already selected “Throttle min. forward / back” in the
“Motor on C1” line of the »
Model type « menu. If this is the case, you can select whether the
motor is controlled by the C1 stick (“yes”) or the braking system (set up in the » Wing mixers «
menu) is controlled by the C1 stick (“no”), separately for each fl ight phase.
Sw. time: at this point you can set a transition time (0 ... 9.9 sec) which applies when you switch into this
phase from any other. This provides a smooth transition between fl ight phases.
Meaning of the symbols in the right-hand column:
indicates the phase assigned to each switch position. This is Phase 1 by default if no other swit-
ches are assigned, or if all phase switches are at the base position.
+ a switch position is provided for this phase in the » Phase settings « menu.
– the phase is not in use.
Display Menu Brief description of menu and operating notes Page