GRAUPNER mx-24s, Programming Manual

Page: 204 / 216

204
Teacher / PC module for
mx
-22 /
mx
-24s
Order No. 3290.22
Required in order to operate the
mx
-22 or
mx
-
24s as the Teacher transmitter for Trainer mode
operations, and for data transfer. The module is
installed in the transmitter, and the 14-pin plug
is connected to the corresponding socket on the
transmitter circuit board. The appropriate opening
is already present in the transmitter case, and the
set includes full installation instructions.
The opto-electronic light-pipe lead (Order No.
3290.4 ) or alternatively the Eco-lead (Order No.
3290.5 ) is connected to the barrel socket. The se-
cond socket is intended for the copy lead (Order
No.
4179.2 ), and is used for transferring data bet-
ween two
mx
-24s transmitters. Alternatively, the
mx
-22 or
mx
-24s / PC interface lead (Order No.
4182.9 ) can be connected to the module for com-
municating with a PC.
Unless you are an experienced modeller, we re-
commend that you ask your nearest
GRAUPNER
Service Centre to install the Trainer / PC module
in your transmitter.
Programming is carried out in the »
Teacher/pu-
pil « menu, as described on page 150.
Appendix
Accessories
Light-pipe lead for Trainer system
Order No. 3290.4
The light-pipe lead is connected to the appropriate
barrel sockets on the Teacher and Pupil modules.
The plugs are marked as follows:
M (Master) = Teacher transmitter
S (Student) = Pupil transmitter
Eco lead for Trainer system
Order No. 3290.5
The ECO Trainer lead is connected to the approp-
riate barrel sockets on the Teacher and Pupil mo-
dules. The plugs are marked as follows:
M (Master) = Teacher transmitter
S (Student) = Pupil transmitter
Trainer lead
Order No. 4179.1
This lead is fi tted with 3.5 mm mono barrel plugs
on both ends, and is suitable for connecting any
two
GRAUPNER transmitters fi tted with DSC so-
ckets.
S M
Trainer lead
Order No. 3290.8
This lead is suitable for connecting a Pupil trans-
mitter with DSC socket (e.g.
mx
-12,
mx
-16s,
mx
-24s) to a GRAUPNER Teacher transmitter
with Teacher socket for the opto-electronic system.
M (Master) = Teacher transmitter
M S
Trainer lead
Order No. 3290.7
This lead is suitable for connecting a Teacher
transmitter with DSC socket (e. g.
mx
-12,
mx
-
16s,
mx
-24s) to a GRAUPNER Pupil transmitter
with Pupil socket for the opto-electronic system.
S (Student) = Pupil transmitter
General notes on Trainer mode operations
The accessories listed on this page, together with
the DSC socket which is installed as standard, en-
able the user to transfer all functions or program-
mable single or multiple functions to a suitab-
le Pupil transmitter for Trainer mode operations.
When you connect the Teacher transmitter to a
Pupil transmitter using the Trainer lead, note that
the plug marked “M” (Master) must be connected
to the Teacher module, and the plug marked “S”
(Student) to the Pupil module.
The individual functions to be transferred are se-
lected in the »
Teacher/pupil « menu (see page
150) of the Teacher transmitter, which can optio-
nally be operated in the following modes: PPM10,
PPM18, PPM24, PCM20, SPCM20 or APCM24.