DSP Components
499
© 2017, ATEÏS, member of PAX ProAV Group
Relay
This Relay function needs to be worked by
using Paging Source function together.
It is able to output a logical High to a
specific output channel in condition of a
zone is occupied by a specific source.
From the picture on the left, the Logic
Output of channel 1 will stay High if the Z1
(Zone 1) is occupied by the paging source
of PSS-AS.
Incompatible
When the zones are under paging, and do not wish
other sound from other paging zones close to the
current paging zone disturbed or covered their own
paging sound. Then users can use the Incompatible
function to avoid this kind of situation.
Enabled: Tick to enable this Incompatible
function.
Zone checkbox: Set the paging zones
which users wish not to be disturbed during
the paging status.
Please see the example picture on the left,
when the zone is paging and Zone 2(Z2)
has been selected for not to paging, the
other paging sources cannot be paging to
Zone 2(Z2), except one condition that the
paging source is higher than the paging
source of Zone 1(Z1). Another example,
when Zone2(Z2) is paging, other paging
sources cannot be paging to Zone1(Z1).
And in this case, Zone(Z1) and Zone(Z2)
will not be proceed paging at the same
time.
5.22
PDC Audio
5.22.1 PDC Input
This component controls and monitors the PDC input signal parameters. The input component represents
the physical analog inputs accessible on the PDC port of the Audio Processor. There are four ports (A to
D) which represent different channels of the PDC port. Some consoles like PSS-AS which transfers audio
signals via PDC port. To process an audio signal with another DSP component, you need to create a DPC
Input component in the design window.
